|
When it comes to soldering iron, its tip is the main part. This is due to the reason tip is responsible for generating heat and conveying it to the material which is being solder. Soldering iron is basically used for soldering purposes by heating a metal and placing that liquid metal into joints of two work pieces. It is used particularly in electronic and electric industries. Just like other equipments, this device also requires a proper care and maintenance to increase its life span. Most of the people use this device in industries as well as for residential uses. But, very few of them are aware of its maintenance tips that can enhance the productivity, provide safety to the operator, and also increases its life. If you are among those who are not familiar with this information, then don’t worry, just read the below mentioned information and implement it at the time of work. Have a look at the tips: Tips: • Purchasing good quality soldering iron is the very first thing you should do. • When not in use, always re-tin your iron prior to placing back in the holder. On the other what most of the people forgot to do is not adequately protecting the tip with solder while it is resting in holder. • If you want to give a small gap between two tasks or work pieces you are soldering, then it would be better to either lower its temperature or turn off it completely. This is due to the reason, in this time fluctuation in electric voltage may cause sparking and even may lit it to fire. • Always use the lowest temperature for soldering. Higher temperature doubles the chances of wear out mechanism. Though, temperature varies depending upon iron, techniques, type of device or work piece you are soldering, and tip construction & size. You can even go for Temperature controlled soldering station. • For cleaning, always use metal wools or copper curls, instead of using wet sponge for cleaning the tip. • In case, you are using a wet sponge for cleaning purpose remember to take made specifically for this only. This is due to the reason a dirty sponge may contain some particles attached to it and that may get reacted when you will clean the tip. It may even damage it. • Try your best to prevent the tip from seizing in the barrel due to loosening of nut and screws that secures it. • Whether in use or not, always place it in the right soldering iron stand. • Plug this iron into correct type of outlet always and also maintain a continuous power supply. Also use right Soldering station always. • Use it softly as a small damage in its ceramic heaters can cause cracking or breaking. • To offer full protection from humidity as well as moisture, use zipper bags for its storage, when not in use. • Temperature is the main factor, so set it always according to the product you are going to solder.
Related Articles -
Temperature controlled soldering station, Soldering station,
| 
