|
Have you ever thought of a scenario where your on going process comes to a halt all of a sudden and the process is completely devastated? This situation could have been prevented if the proper calibration of the equipments was done or the equipments employed were tested prior the use in the process. So as they as we must always test the equipments before they are put to constructive use. Equipments are made to lessen the pressure of man not to stress our minds so it is very essential to test the equipments. If the equipments do not undergo any test before use the consequences could be severe and sometimes even lethal. So now let us diversify our knowledge by discussing the advantages of testing industrial equipments. Some of the basic advantages are discussed below: Accuracy and precision: for the results to be precise and accurate the equipments to be used must go through thorough testing because during testing the flaws can be diagnosed and fixed later so that it doesn’t create any mess during the process. In industries, the accuracy matters a lot that sometimes a slight difference in the result can cause a failure in the running process. So to achieve exact results pre testing of equipments is mandatory. Safety: safety is another important factor to be kept in mind in industries. Testing equipments before they are put to use can avoid accidents in industries. During testing the flaws can be diagnosed and can be worked upon before they are put to actual use. Sometimes during testing we get to know about various hazards that could cause industrial accidents and thereafter modifications are made accordingly. Saves time: The proverb ‘a stitch in time save nine’ fits well in this case. A timely check and inspection of equipments can save a lot of time in industries where practical processes run. If a problem is detected before the start of operation it can be dealt with but if the same problem is detected after the start of operation or during the course it can cause various troubles. The entire operation needs to put to halt or a new operation has to be started which wastes time and raw material as well. Degradation of the product: starting a process without testing the equipments can also deteriorate the quality of ultimate product. So it is better to take a precautionary step in the beginning to avoid all such problems. Testing of equipments involves: 1.Checking if it is running properly without any trouble. 2.Checking if the wiring in electrical equipments is proper. 3.Checking if the products to be added in the equipments are as per norms mentioned. 4.Checking the physical state of the equipment. Keeping these factors in mind we should adopt the phenomenon of testing equipments so that it doesn’t create any problem during/after the course of the process. Also, proper and frequent inspection is equally important. Equipments are machineries which require proper maintenance to function positively. Humidity Meter, Digital Timer and ORP Meter are two important devices used in manufacturing industries to check the humidity level which can be crucial to a number of manufacturing process. Therefore it is advised that you purchase quality instruments so that you might not end up on the losing side.
Related Articles -
Data Logger, Humidity Controller, Amp Hour Meter,
| 
