Raymond common faults and causes Remedy
1, no flour or a flour-less low yield.
(1) lock powder unadjusted good Mifengbuyan, resulting powder suck down.
(2) blade wear big, materials shovel can not afford.
(3) duct blockage
(4) Pipeline leak sealing well.
(1) check and adjust lock powder sealed, to find leak at Blade.
(2) replacement blade.
(3) to clean up the air duct material, re-cutting.
(4) sealed pipeline.
2, finished powder is too coarse, or too small.
(1) analysis of turbine blades wear serious, and can not afford the hierarchical role.
(2) The fan flow is inappropriate.
(1) Replace the blade length appropriate off fan air flow into the resolution is too coarse.
(2) too small and should increase the amount of inlet air.
3, host current rise in machine temperature rises, the fan current drops.
(1) excessive feed duct powder clogged pipe exhaust, poor circulation airflow fever so that the main current, machine temperature rises, the fan current fall.
(1) reducing the feed rate, the clear duct plot powder.
(2) open big I duct valve, the temperature of the material of the machine which is controlled at 6 ?.
4, the host noise and a large vibration.
(1) The feed rate is small. The blade badly worn shovel can not afford the materials, anchor bolts loose.
(2) material hard impact, or feed material layer
(3) The grinding roller grinding ring out of round deformed.
(1) Adjust the feeding amount, replacement blade.
(2) replacement of feed size.
(3) the replacement of the roller, grinding ring.
5, fan vibration.
(1) Blade on of accumulated powder or wear is uneven.
(2) anchor bolts loose.
(1) Clear leaves accumulated powder or replace the blade.
(2) tighten the anchor bolts.
6, transmission and analysis of machine oil tank heating
(1) Oil viscosity Spodiopogon thick, the threaded pump oil not hit up the upper bearing short of oil.
(1) Check the oil grade and viscosity is consistent with the requirements.
(2) Check the running direction of the Analytical Engine
7, the the roller device into powder bearing loss Cup.
(1) off the oil, or seal damage.
(2) long-term lack of maintenance and cleaning.
(1) at the stipulated time refueling in a timely manner.
(2) regular cleaning, replace seals.
Related Articles -
Raymond, common, faults, and, solutions,
| 
