|
For those of you who have purchased an old home with the purpose of renovating it for your long-term abode the last place you probably want to touch is the basement. However, this might be a good place to start because many of the ills of any home begin in this space. If you are going to renovate the basement do it one step at a time like you were taking off winter clothes. Take everything out of the basement area first, even the pictures off the wall and put them in a mini-storage. The reason for this so that no other areas of the home get cluttered while you are trying to work. One disheveled area in the home is enough. Ceiling: Once the place is cleaned out start with the ceiling. If this is a drop ceiling then you are in luck but make sure you wear a face mask and goggles because dust and other debris (mouse and rat feces) will collect on top of the panels. Because ceiling panels are fairly cheap, and difficult to clean, it is best to put them in the dumpster. Then take your sop vacuum cleaner and clean the railing. If your ceiling is drywalled you have a choice on whether you want it to come down especially if you know where all the ductwork is. But most of the time you won't have a clue where anything is up there so get your wrecking bar, face mask and goggles and get it down. It's better to do it now that when you've refinished the basement and then have a leaky pipe above. You can replace this with drop ceiling later and have easy access to any futures problems that may occur above the ceiling. Floors: If the carpet is glued to the cement the foam backing may stick to the floor. An ice scraper usually does the trick to get this off. If the floor is tile-on-cement then you might look a leaving it and using it for a subflooring. It's hard and flat just like the cement. But any wood subfloor should be taken out. Walls: There is an old adage in renovating, “You never know until you break it open.” If the basement is old there is a good chance that, without the modern ventilation methods, there is mold behind the walls. Even if there isn't any when you take the walls out the insulation they put up in the 1960's probably has outlived its usefulness and you want to check it out. Again get your protective face, eye and hand coverings and take off the wallboard or drywall. Insulation: This should be taken out and bagged and the whole area vacuumed. Framing: This is good time to check the wall studs. If there is rot it will have to be replaced. Sometimes you can get away with just replacing the bottom stud, or footer, with a pressure-treated board. The nails can be cut along the joint with a reciprocating saw and the new pieces toed-in without much trouble. If the bottoms of the studs are showing rot it would be best to take it all out and salvage the good pieces. Load-Bearing Walls: If the footer of a load bearing wall shows rot then you can get a couple of jackposts and place them right beside the wall to accept the weight. Then you can take the wall apart and rebuild it. These posts are adjustable and work better than a wood alternative. Windows: If your home has bedrooms or living spaces in the basement, you are required by law to install egress window wells for easy escape in case of emergency. If the lowest level of your home is slightly above ground, then egress window installation with be simple. However, it’s more likely that you will have to make some special alterations. Mold: Even if mold does not seem to be evident spray the lower areas with a fungicide. If there is mold the studs will have to come out. These can be taken outside and cleaned and then they can go back in. Handy American. “Renovating the Basement.” March 2011.
http://www.handyamerican.com/articles-renovating-the-basement.asp
Related Articles -
egress, window, wells,
| 
