During the hot summer months, a pool can be the perfect place to cool off and relax. Spending time in a pool that is a sparkling and beautiful blue can be the perfect escape from a busy or stressful day. However, when the filtration system of a pool stops working correctly, that beautiful retreat can quickly become a disgusting nightmare. Sometimes fixing the problem can be simple, such as replacing a filter. Other times, fixing the problem can be a complex and potentially expensive repair that involves replacing numerous parts. If your pool seems to be having issues, here are some tips for pool pump troubleshooting in Naples, FL. Giving these ideas a try may just solve your issue and get the water flowing again. Pump Keeps Turning On and Off If your pump is cycling on and off, there could be several issues. One potential issue is loose wiring. Pumps tend to vibrate a lot and that can sometimes shake the electrical connection loose. Before checking a wiring connection, you should always make sure that power is turned off to the pump. If you are unsure, you can also have an electrician or pool specialist check it for you. Another possibility is that the pump is working too hard and is overheating. If the pump has a thermal protection circuit, that circuit will protect the pump from overheating by shutting it down to allow it to cool. Once the pump cools down, it will allow the pump to turn back on. If the pump feels hot to the touch when it is off, there is a good chance that this is the issue. Air Bubbles from the Jets If you notice that there are a lot of bubbles coming from the jets, you most likely have an air leak somewhere in the pipes or in the pump. If air bubbles are coming from all the jets, the leak is likely close to the pump. However, if only one or two jets are releasing air bubbles, the leak may be in a seal close to those jets. Check all of the joints you can access to ensure that they have a good seal. If you find one that is loose, tighten it up and see if that fixes the issue. If you are unable to track it down, you may need to have a professional come and examine your plumbing to locate and correct the issue. Pump Seems Excessively Loud A pump that is making a lot of noise could have several different issues. One possible issue could be that it is vibrating against the floor or pad it is resting on. Placing a carpet square or piece of rubber underneath the pump can dampen those vibrations and reduce the amount of noise the pump is making. Another possible source of noise could be a bad bearing. Pumps have bearings inside that allow everything to turn smoothly. When the bearings stop turning smoothly, they will begin to make more noise. This type of problem will require a professional to open up the pump and replace any bearings that have gone bad. Enjoying a pool in the heat of the day is a great way to keep cool. It can provide hours of fun for the entire family and make your house the most popular one in the neighborhood. However, if your pool starts to have issues, try starting with these tips for pool pump troubleshooting in Naples, FL. Sometimes correcting your pool’s issue can be a simple fix that can be implemented quickly and easily. However, if you are unsure or cannot figure out what is wrong, be sure to call a professional to make sure your problem is fixed properly.
Related Articles -
pool, pump, troubleshooting, naples, fl,
|