Bicycle tire has a characteristic, if you are not successful, then this tire useless. There are two reasons for the failure: 1 tire glue is not dry or tire patches pasta. The solvent in the gel during the evaporation process, and the tread of the tire are formed between the passage of gas and discouraged.cycling wear If you're too impatient, pasta, Tire Tire Patches Patches is also available on the slide of the tire, in practice this tire on the death penalty. 2 tire tread between the plate and not in the air, the same tire in the tire and the gas passage is formed between the sheet and discouraged. Tire cycling process is most often encountered the problem, then it really takes to fill the tires, you should pay attention to what point? 1 carefully to find a breaking point. It can be used only in nature around the ear. Better preparation for a crayon, scored the first point of break and then started to work. 2 Carefully break point four weeks to play rough. Especially when the point of rupture in the pipe close to the dividing line, but be careful to put a line of mold polished tube. 3 glue must break point with a radius of about 15mm, first draw a circle with glue, and then point average to break the glue. Reason: In terms of the first break point of the glue, and then gradually glue, because the glue is not easy to visually see after break point can easily lead to tire after the break point is not in the middle of chip of tire, tire a high probability of failure. 4 Apply glue to wait after a dry surface, seems to be gray, rather than the shiny polished, and put pieces of tires. 5 piece on the tire after a hard place to find an apartment, spread on top of the tire, with the instrument is gradually breaking tapping hole to determine the air. 6 Carefully inspect the tire, be sure to find the tires bar guilty, if necessary, take needle nose pliers to get ready to pull the nails. 7 Replace the inner tube to be smooth to avoid tubeless tire and the rolling circle has been broken.
Related Articles -
cycling, wear,
|